KBC Networks ESML6-P3 - Manual (Page 9)

Ethernet Switch User Manual
Manual_cmd_line_config-ESML6-P3-Rev1106
Copyright © KBC Networks Ltd. Page 8 of 49 www.kbcnetworks.com
fdb fdb configuration
history display the session command history
igmp IGMP protocol
interface interface status and configuration
link-check show link-check information
lldp show lldp information
mirror show mirror information
port-rate port rate configuration
pvlan show pvlan information
qos show qos information
rmon show rmon information
rstp show RSTP information
running-config current operating configuration
serial-num device serial number
snmp SNMP status
sntp SNTP table
ssh configure ssh service
switch show switch status
tacacs+ show tacacs+ information
telnet Telnet configuration information
timer show timer message
trunk show trunk information
uptime display the system uptime
version software version information
vlan show vlan information
2.2.4 Symbol in Command
In the management software, only one symbol ‘< >’ is supported. It means a parameter
is required in this part of the command.
Example:
dt-ring new <1-32> domain <1-32> master