KBC Networks ESML6-P3 - Manual (Page 38)

Ethernet Switch User Manual
Manual_cmd_line_config-ESML6-P3-Rev1106
Copyright © KBC Networks Ltd. Page 37 of 49 www.kbcnetworks.com
SWITCH(config)#snmp reqport <1-65535>
The parameter <1-65535>: Requested port number.
Trap port number:
SWITCH(config)#snmp trport <1-65535>
The parameter <1-65535>: Requested port number.
Note: If the request port number is set, the port number for the EMS server which will
send the request messages must also be modified otherwise the connection will not
work.
12.2.5 Setting the number of EMS management stations
The number of the EMS management station is the number of devices allowed to be
connected. Controlling this number will assist with controlling the communication load
and enhance security. The ageing time of a management station is 1 minute. During this
period of time, the management station is not connected to other devices and its IP
address is also removed from EMS IP list.
Setting the number of management stations
SWITCH(config)#snmp emsnum <1-3>
Where <1-3> is the number of the management station.
12.2.5 12.2.6 Enable/Disable Trap
Enable Trap :
SWITCH(config)#snmp trap enable
Disable Trap :
SWITCH(config)#snmp trap disable
12.3 Display the SNMP Status
Display SNMP Status :
SWITCH#show manager
Display the SNMP protocol enable/disable status, request/trap port number and EMS
management station number.
Display SNMP read/write community name:
SWITCH#show snmp community
Display connected devices EMS IP address list:
SWITCH#show snmp emsiplist