KBC Networks ESML6-P3 - Manual (Page 11)

Ethernet Switch User Manual
Manual_cmd_line_config-ESML6-P3-Rev1106
Copyright © KBC Networks Ltd. Page 10 of 49 www.kbcnetworks.com
This command line can be abbreviated to:
SWITCH>
SWITCH>ena
SWITCH#con ter
SWITCH(config)#
SWITCH(config)#vlan 2
SWITCH(config-vlan2)#desc market
SWITCH(config-vlan2)#add port 1 un pr 0
The two commands above have the same function.
2.2.7 History Command
The switch software keeps a record of the last 10 commands the user has typed in. To
show the command history list, use the following:
SWITCH#show history
2.3 Common Commands
Below are some of the more common commands.
2.3.1 Mode Configuration
The CLI provides two modes: Read Only and Configuration. Using the Read Only mode,
the user can only read a part of the system configuration information. Using the
Configuration Mode, the user can read and configure all the system configuration
information and also use some commands to enter certain protocols independent of the
Configuration Mode.
Read Only mode, the prompt ends with ‘>’ i.e. ‘SWITCH>’
Configuration mode, the prompt ends with ‘#’ i.e. ‘SWITCH#’
To enable the Configuration Mode go into the Read Only Mode and type the command:
SWITCH>enable
Select . If a password has been set up it should be entered here.
Password:
After entering the password you are now in the Configuration Mode. To come out of
Configuration Mode, use the following command:
SWITCH#disable