Drylam Fujipla ALM3220 - Manual (Page 46)

AL-MEISTER ALM3220 Instruction Manual
46
Instructions for DryLam product CLKIT (Cleaning Kit) :
Be sure to clean the heat chambers only when the laminator is cool.
Moisten the sponge pad with Xenit leaning fluid and wipe down the heat chambers. CAUTION: Coated
heat chambers are easily scratched. Use only the recommended applicator pad.
Xenit Cleaner is not a solvent or a lubricant. The DryLam Maintenance Kit contains a Dry Film
Lubricant for the heat chambers and is highly recommended after cleaning.
Instructions for DryLam product 01300 (Maintenance Kit) :
After cleaning the chambers, as described above, it is HIGHLY recommended to use the
DryLam Maintenance Kit (DryLam part number 01300). Be certain the heat chambers are clean
(see above). This product is not a cleaner or a solvent.
The Maintenance Kit includes Dry Film Lubricant (without silicone!) and a microfiber cloth.
After the face of the chambers have been cleaned spray a liberal amount of the Dry Film
Lubricant into the microfiber cloth and wipe on the face of the heat chambers. There will be a
glossy shine afterwards. Wipe off the excess but do not remove the residue of the lubricant.