Drylam Fujipla ALM3220 - Manual (Page 14)

AL-MEISTER ALM3220 Instruction Manual
14
2. COMPONENT NAMES AND FUNCTIONS (cont’d)
2-6. OTHER OPERATION SWITCHES
Open the trimmer cover.
1) Manual MOVE Switch
Use to set/feed film or to take out paper when it is stuck
To feed forward, turn the switch to left.
To feed backward, turn the switch to right.
* Set the trimmer adjuster to Film Set position.
2) Manual CUT Switch
Use when setting film or cutting film which is stuck in the laminator. It only works
once.
*It does not work when a cutting error has occurred.
CAUTION: Manual Switch works on any setting. Account for all film going into the machine. If film does
not exit the discharge in less than 5 seconds
STOP! Film may be accumulating within the machine. If this
is allowed to continue, damage to the machine will occur.
*If you believe an excess amount of film has gone into the machine release the MOVE switch. Raise the
Lamination Handle and pull the film back out the front of the lamination area. Use the MOVE switch to
assist.
*When you use the manual MOVE Switch, move enough film out the discharge to grab on to. Then CUT
the film by using the manual CUT Switch. Pull out the cut film/paper from the discharge.
*After the film waste has been pulled from the discharge the machine is ready to be run in automatic
mode. Do NOT run the MOVE switch again unless CUT is performed immediately afterward.