Drylam Fujipla ALM3220 - Manual (Page 12)

AL-MEISTER ALM3220 Instruction Manual
12
2. COMPONENT NAMES AND FUNCTIONS (cont’d)
2-5. LCD
POWER UP/WARM UP
When powered up the LCD will indicate the model and
software version.
In a few seconds the LCD will indicate that the machine is
being heated up.
Operation is not possible during this time.
1) Indicates the set temperature in Fahrenheit.
When the machine’s heat is being regulated the buzzer beeps three times.
READY appears if machine is fully heated. If the machine has been properly threaded it is ready to be
run in automatic mode. To thread the machine see chapter 3 on page 13.
2) [TEMP] indicates the set temperature in Fahrenheit.
3) [SPEED] indicates the set speed in inches per minute.
4) [MARGIN] indicates that the trimming and cutting is with/without margin on the front and back
(leading and trailing edges) of the laminated paper. NOTE: A “margin” is a (sealed) edge of film
around the laminated paper.
Example: MARGIN:
ON
•• A 0.12"laminated margin has been added to your CUT ADJUST setting.
OFF •• No laminated margin has been added to your CUT ADJUST setting.
5) [SET COUNT] indicates number of the papers to be processed.