Drylam Fujipla ALM3220 - Manual (Page 43)

AL-MEISTER ALM3220 Instruction Manual
43
“TEMP. SENSOR
BREAK” error The problem will be solved in most cases. If the
problem is not solved or happens frequently
contact your dealer or DryLam Tech-Line. Do
not dismantle the machine unless instructed.
“TEMP. SENSOR
SHORT” error
“LAMINATION
MOTOR ERROR” or
“MAIN MOTOR
ERROR” errors This is different than
“LAMINATION ERROR”
(see above for this
error). Turn off the power and turn back on. The
problem will be solved in most cases. If the
problem is not solved or happens frequently
contact your dealer or DryLam Tech-Line. Do
not dismantle the machine unless instructed.
TRIMMER DOES
NOT CUT WELL Lamination scrap is
stuck in trimmer
section. Contact your dealer or DryLam Tech-Line. Do
not dismantle the machine unless instructed.
LEFT AND RIGHT
MARGINS ARE NOT
EQUAL Paper not centered
within the film area
Set Trimmer levers to Position Of Film Set.
Push the START button and laminate one sheet
of paper. Look at how the paper is centered
within the film area. If it is not centered adjust
the paper tray adjustment screw (or the paper
tray guides) to center the paper within the film
area. Set Trimmer levers as desired and run
again.
Check if the trimmer
adjustment levers are
correctly set. Adjust the trimmer adjustment levers. It may
be necessary to set the levers at positions that
do not have slots. You may set the levers at
any position desired, then secure with
magnets.
Check if the paper is fed
correctly. Paper may be
skewing on the Feeder
Tray. If paper is skewing within the film area adjust
the Paper Pressure adjustment lever. Lowering
the lever will apply less resistance to a second
sheet of paper entering the Feeder. This will
improve skewing but may cause more than
one sheet to enter the Feeder.
CREASES APPEAR
IN THE LAMINATED
FILM Tension knobs too
loose. Tighten the tension controllers slightly on each
side of the film rolls. Do not apply any more
tension than necessary.
Error messages specific to version B03.1 (serial numbers 805, or greater,
machines shipped to North America after Sept 2011)
“DISCHARGE
ERROR - CALL FOR
SERVICE” The manual feed switch
will be disabled to
prevent damage to the
machine. Turn the power off and back on again to
activate the switch. Carefully remove all sheets
that are stuck within the machine. Understand
that use of the MOVE switch may cause
damage to the machine if stuck paper is not
removed properly.
“PAPER STUCK -
CALL FOR SERVICE” For diagnostic purposes
one, or more numbers Turn the power off and back on again to
activate the MOVE switch. Carefully remove all