2-4. set counter, Automatic operation (cont’d) – Drylam Fujipla ALM3220 User Manual

Page 30

Text mode
Original mode

AL-MEISTER ALM3220 Instruction Manual

5. AUTOMATIC OPERATION (cont’d)

5-2-4. SET COUNTER

Press MODE key.

Move cursor by using UP or DOWN key.

Press MODE key to confirm.

[SET COUNT]
Set the number you want to laminate.
NOTE: Defaults to MULTI after power outage.
[MARGIN SET]
Make cuts either with, or without margin.
NOTE: Defaults to MARGIN ON after power outage.
[CUT ADJUST]
This parameter adjusts the cutting positions at the leading and trailing edges of each sheet.
NOTE: These settings are retained in memory after a power outage.
[TOTAL COUNT]
Total Count indicates the accumulated number of laminations since the RESET button was pushed.
NOTE: This record is retained in memory after a power outage.