Drylam Fujipla ALM3220 - Manual (Page 38)

AL-MEISTER ALM3220 Instruction Manual
38
5. AUTOMATIC OPERATION (cont’d)
5-5. ECO MODE (Power Saving Mode)
ECO MODE enters when the machine is idle
and any buttons on the operation panel*
have not been pressed in the past 15
minutes.
*This does not apply to the “MOVE” switch.
A buzzer will sound 1 minute before entering
ECO MODE. ECO MODE will be deactivated by
pressing any key. The 15 minute timer then starts again.
1) Current temperature
2) ECO MODE temperature goal (130F)
5-6. TERMINATE LAMINATION
1. Make sure the lamination has finished.
2. Turn off Power Switch. Disconnect the power plug.