Doremi DSV-J2 - Manual (Page 61)

15.2.7.4 CueType Node [optional]
The CueType element corresponds to the type of Cue used by the TriggerCue. The available
Cue Types are listed in the table below:
Table 3: Cue Types Available
Type Description
GPI Allows assignment of a GPI line and value to the Trigger
Signal Allows assignment of another signal to the Trigger
15.2.7.5 CueTypeParameters [optional]
The CueTypeParameters element contains the parameters associated to the Cue type defined
in the CueType element (Figure 57).
Figure 57: TriggerCue Structure
Dotted lines denote optional elements that can be omitted during the creation based on
the Macro Editor.
 For GPI Cue Type, the two following parameters have to be used: Line and Value.
The Line element specifies the GPI line number to be used for the associated command. It
contains an integer to be chosen between 0 and 7.
The Value element indicates the state of the GPI: ON (Value = 1) or OFF (Value = 2).
 For Signal Cue Type, the following parameter has to be used: Name.
The Name element specifies the signal name.
DSV.OM.000391.DRM Page 61 of 68 Version 1.3
Doremi Labs