Doremi DSV-J2 - Manual (Page 17)

The GPIO cable delivered with the DSV-J2 with a Dolphin DCI installed has an exposed wire
end as shown here (Figure 17):
Figure 17: Dolphin DCI GPIO Cable
The GPIO channels are tagged on each wire of the exposed end to facilitate GPIO channel and
signal/ground identification.
4.2.3 Digital Audio (AES/EBU)
The digital audio interface of the DSV-J2 is provided on a female DB-25 connector on the rear
panel of the unit (Figure 18). Currently, 16 channels of balanced AES/EBU digital audio are
provided. The pin-out for the digital audio connector is shown in the table that follows. The pin
numbers are defined on the front face of the female DB-25 connector (Figure 18):
Figure 18: Digital Audio Interface
The AES/EBU digital audio DB-25 connector pin-out follows:
DSV.OM.000391.DRM Page 17 of 68 Version 1.3
Doremi Labs
Pin 1
Pin 25
Pin 2
Pin
13
Pin 14
Connector to be
plugged into the
DSV-J2 GPIO
connector
Unwired end