Doremi DSV-J2 - Manual (Page 23)

6 Device Manager Configuration
The Device Manager is a graphical user interface used to setup the connection between a DSV-
J2 and cinema projector(s). It also provides for the use of Ethernet commands for the control of
theater automation devices.
To run the Device Manager, go to Menu → Doremi Apps. → Device Manager.
The following window should appear on the screen (Figure 24):
Figure 24: Device Manager Graphical User Interface (GUI)
6.1 Projector(s) Management
The DSV-J2 to projector setups does not have Cinelink encryption and therefore the projector
should not be setup in the Device Manager.
6.2 Automation Libraries Management
Support for theater automation control through Ethernet is also provided. The list of currently
supported devices is the following:
 eCNA
 JNior
A pre-built library of supported automation commands is available for each of these two devices.
These automation commands can then be added to Macro Cues as presented in section 7.2.
6.2.1 eCNA Device
6.2.1.1 eCNA Device Addition
To use the eCNA device, click the Add button and select eCNA.
Then enter the eCNA device IP address in the appropriate field as presented below (Figure 25):
DSV.OM.000391.DRM Page 23 of 68 Version 1.3
Doremi Labs
Add
button