Doremi DSV-J2 - Manual (Page 45)

11.5 Software/Firmware Upgrade
11.5.1Sending the Software File to the DSV-J2
To send a new software update file to the DSV-J2, use an FTP client and login as follows:
 type: ftp 192.168.100.50 (enter the IP address of your DSV-J2)
 when prompted for a user name, type: admin
 when prompted for a password, type: 1234
 type: bin
 type: cd ./etc/rc.once
 type: put dcp2000_patch-0.5.2-26.pkg (dcp2000_patch-0.5.2-26.pkg is the
upgrade file that you received from
Doremi)
 When the transfer is completed, type: bye
Note: These steps may vary depending on your FTP client and whether you are on a Linux or
Windows PC. The login information, file names, and destination folder are the same in either
case.
11.5.2Performing the Software Upgrade
To perform the upgrade of the DSV-J2 software, simply reboot the DSV-J2.
To do this, login as root and from the terminal command prompt, type: reboot .
Once the DSV-J2 has rebooted, login again, open the terminal command prompt and type: halt
.
This will initiate the shutdown of the DSV-J2. After 20 seconds or so, the unit will shut off
automatically. After the DSV-J2 has shutdown, power it on again and login as you normally
would. This will complete the software update.
11.5.3Sending the Firmware File to the DSV-J2
To send a new firmware file to the DSV-J2 JPEG-2000 decoder, use an FTP client and login as
follows:
 type: ftp 192.168.100.50 (enter the IP address of your DSV-J2)
 when prompted for a user name, type: admin
 when prompted for a password, type: use the admin password here
 type: bin
 type: cd ./etc/rc.once
 type: put fw-1.53.pkg (fw-1.53.pkg is the upgrade file that you received from
Doremi)
 When the transfer is completed, type: bye
Note: These steps may vary depending on your FTP client and whether you are on a Linux or
Windows PC. The login information, file names, and destination folder are the same in either
case.
DSV.OM.000391.DRM Page 45 of 68 Version 1.3
Doremi Labs