CIRCUTOR CDP-0 User Manual
Dynamic power control, Cdp- 0, cdp- g, Instruction manual
This manual is related to the following products:
Table of contents
Document Outline
- 3.5.1. AUXILIARY POWER SUPPLY
- 3.5.2. COMMUNICATIONS CONNECTION
- 3.5.3. VOLTAGE MEASUREMENT AND CURRENT CONNECTION
- 4.1.1. DESCRIPTION OF THE MEASUREMENT SYSTEM
- 4.1.2. OPERATION OF THE GRID INJECTION PROTECTION RELAY
- 4.1.3. MANAGEMENT OF NON-CRITICAL LOADS (CDP-G Model)
- 4.2.1. BASIC SINGLE-PHASE CONNECTION
- 4.2.1.1. Voltage connection
- 4.2.1.2. Current connection
- 4.2.2. SINGLE-PHASE CONNECTION WITH MONITORING
- 4.2.2.1. Voltage connection
- 4.2.2.2. Current connection
- 4.2.3. BASIC THREE-PHASE CONNECTION
- 4.2.4. THREE-PHASE CONNECTION WITH MONITORING
- 4.3.1. SINGLE-PHASE INSTALLATION WITH 1 LOAD TO BE CONNECTED
- 4.3.2. SINGLE-PHASE INSTALLATION WITH 3 LOADS TO BE CONNECTED
- 5.2.1. DHCP ASSIGNMENT
- 5.2.2. DHCP OPTION: YES
- 5.2.3. DHCP OPTION: NO
- 6.1.1. CDP Setup
- 6.1.2. Power control & Data logger
- 6.1.2.1. Inverter
- 6.1.2.2. Control
- 6.1.2.3. Inverse current relay
- 6.1.2.4. Auxiliary load relays
- 6.1.2.5. Data logger
- 6.1.3. Analyzers setup
- 6.1.4. Network & Security Setup
- 6.1.5. Save setup, Load default setup and Reset CDP
- 6.2.1. CDP AS A DATA LOGGER