CIRCUTOR CDP-0 - Manual (Page 46)

CDP
46 Instruction Manual
6.- COMMUNICATIONS
The unit has two web sites:
 Configuration web site.
 Display web site.
6.1. CONFIGURATION WEB SITE
The CDP can be used to configure the parameters of the
Table 15 , via Web.
Table 15: Configuration parameters.
Description Units
Default
value
Inverter type - Fronius
Inverter power W 1
Number of inverters - 1
Work mode configuration - Single-phase
Activate compensation - 0
No injection threshold % 3
Permitted power to be injected % 0
Activate the management of non-critical loads - disabled
Maximum modulation value % 50
Relay connection order - Priority
Maximum grid contribution value % 25
Minimum reconnection time Minutes 5
Power to be consumed by each of the loads connected
to the relays
W -
Minimum time that the load must stay connected Minutes 15
Activate reverse current relay - 1
Grid injection validation time Seconds 0
Reconnection time Seconds 0
Maximum number of reconnections - 0
Reconnection period Seconds 0
Time between datalogger logs Minutes 15
Activate external unit to measure the user's current - 0
Transformation ratio for the current of L1 (Channel for
measuring the user's current in single-phase mode)
A/250 mA 1
Peripheral number address
(External unit activated)
- -
Transformation ratio for the current of L2 (Channel for
measuring the grid's current in single-phase mode)
A/250 mA 1
Peripheral number address - 1
Activate external unit to measure the inverter's current - 0
Transformation ratio for the current of L3 (Channel for
measuring the inverter's current in single-phase mode)
A/250 mA 1
Peripheral number address (External unit activated) - 2
Communication speed with the grid analyzers. Bauds 19200