CIRCUTOR CDP-0 - Manual (Page 55)

CDP
Instruction Manual 55
Figure 71: Setup web site: Auxiliary load relays (Manual).
You can manually activate each relay by pressing the corresponding button for
each one.
If you select dynamic management of the loads (
Figure 72 ), you have to program
the following parameters:
Figure 72: Setup web site: Auxiliary load relays (Dynamic).
• Max. modulation value: In this section you enter the maximum modulation
value and can add dynamic loads to the system below.
• Connection Order: Select how you are going to connect the relays: By pri-
ority or rotating
• 1st/2nd/3rd Priority: If you have selected priority connection, you will then
select the priority for each of the relays.
• Max. grid contribution: In this section you enter the value for maximum grid
contribution, which is the minimum value for deactivating loads.
• Reconnecting time: Minimum time to allow system stabilisation between:
- the activation of two loads.
- the deactivation of two loads.
- the deactivation of the last load and the activation of a new one.