AVUE G55IR-WB36N – Outdoor 36X Long Range IR PTZ - Manual (Page 8)

Function Instruction
This passage mainly describes the main function and general principle of intelligence PTZ, and not
refer to the concrete operation methods. Different system platform has different operation methods, generally,
should according to the system manufactory's operation manual. Please contact dealer to get necessary
information, there are some particular requirements and operations under specific condition.
and SW2 is for setting communication baud
rate and controlling protocol. (For detail setting, please refer to 10.5 DIP switch setting)
Besides the factory protocol(FACTORY), the PTZ is compatible with various popular protocols, such as
PECLO-D, PECLO-P, ERNITEC, VCL, MOLYNX, VICON, SANTACHI, PANASONIC, SAMUNG,
DIAMOND, KALATEL, LILIN, PHILIPS, VIDO B02 AD and so on.
Any controlling command must base on the objective camera address, and the camera only answer to the
controlling command address which coincide with itself. There are three kinds of camera address:
When manually adjusting, for far focus situation, the PTZ responds at a high-speed so that touching
rocker slightly may make picture move rapidly, thus cause the picture to lose. To base on humanized design,
the PTZ automatically adjust pan and tilt rotation according to zoom near and far, which make it is
convenient to operate manually to make tracking for the object. In the menu, you may change system
parameter setting proportion pan as ON to run this function.
If user holds the joystick in the down position, the camera rotates pan 180 degrees, he camera
rotates tilts up to 180 degrees . In the menu, you may set the system parameter setting AUTO FLIP as ON
to run this function.
By the menu park time and park action , user may set auto-call preset or run tour, pattern, and
scan, etc after pointing a few minutes if the PTZ doesn't run any motions.
By the menu power up action , after the PTZ powers up or restarts, user may set auto- resume
movements before power up and auto- call preset or run tour, pattern, and scan etc .
Camera ID
Auto-run motion
Auto flip
Power up action
Use camera's switch number to set address 1-8 bits, the address range is 1-254.
Debug address: (Only factory protocol and PELCO can be set) if camera ID is set 0, user may select
any address to control the PTZ.
3.1
3.2
Park action
There are two 8-bit switch SW1 and SW2 on the commutator,
，
“ ” “ ”
●
● Common address:
Ø
Ø
Ø
Ø
Focus/speed proportion pan
“ ”
then t
3. Function Instruction
5