AVUE G55IR-WB36N – Outdoor 36X Long Range IR PTZ - Manual (Page 37)

8. Alarm function
Alarm Function
AUX2
GND
1 2 3 4 5 6 7
ALARMS
AUX1
earthing
Alarm input 1-7bits
Alarm ouput 1
Alarm output 2
The PTZ may connect with 7 alarm input, 2 alarm output, and support ala-
rm linkage. The external alarm message sends to the PTZ, then the PTZ sends to
alarm point shoot (to call preset, auto scan, auto cruise and auto pattern), and choose
that to run alarm output or not.
The system enters into the main menu by calling 95 preset or by calling 9 preset
twice within 3 seconds. click each menu according to the left picture, then enter m-
enu alarm, choices as follow:
alarm number is corresponding with 12 bits plug in
the external switching board of the PTZ (as below shows). 001 priority is
the highest, 007 priority is the lowest. The two lines alarm input at the sa-
me time, the PTZ run alarm that the highest priority.
as current alarm input, to run the action. Choices for
choosing as follow. NONE---none action/SCAN/PAT X---run a pattern tour
/TOUR---run tour/PRESET---call preset, when the PTZ number is set as 1,
to call preset 1; when the PTZ number is set as 2, to call preset2.
as current alarm input, to run alarm output or not. NO-
NE---none alarm output/AUX 1---the first alarm output/AUX 2---the sec-
retaryond alarm output/BOTH--- two alarms output.
ALARM PRIORITY alarm priority can be defined as three grades:
high, middle, low.
resume mode after relieving alarm input, there are two choi-
ces: ON---clear alarm output, the PTZ will stop.
OFF---just clear alarm output.
SEQUENCE The park time between two alarm in the same priority, the
range is 1-60s.
set alarm reset and delay the time (1-225s) how long
to relieve and run RESUME after the PTZ receives alarm message.
set state of the relay. N/C---often close the state,
N/O---often hold the state. If setting as often closing the state, the relay is
in closing the state when there is no alarm to output; when there is alarm to
output, the relay is in holding the state.
AL
to ALARM SETTING , press OPEN
to enter the menu alarm setting
，
1
ALARM CONTACT
ARM SETTING
ARM SETTING
2 Operate joystick, move the cursor
ALARM NUMBER
ALARM ACTION
ACTIVATE AUX
、
●【 】
【 】
●【 】
●【 】
【 】 【 】
●【 】
●【 】
●【 】
●【 】
●【 】
●【 】
●【 】
、
RESUME
RESET DELAY
ALARMS
RESUME OFF
SEQUENCE 002
RESET DELAY 020
ALARM CONTACT N/C
ALARM SETTING
ARM SETTING
BACK
EXIT
ALARM SETTING
ALARM NUMBER 001
ALARM ACTION TOUR
ACTIVATE AUX NONE
ALARM PRIORITY HIGH
BACK
EXIT
34
MAIN MENU
SYSTEM SETTING
CAMERA SETTING
FUNCTION SETTING
WINDOW BLANKING
ALARMS
LANGUAGE
EXIT