AVUE G55IR-WB36N – Outdoor 36X Long Range IR PTZ - Manual (Page 17)

L ED 2
L E D 1
4.5.6 Advance setting
These function in the advance setting menu depends on the models and
parameters of built-in camera in PTZ, if the camera haven't this function,
then this function is invalid.
The option is useless (N/A) when the camera module has no such function.
1.After the PTZ set the EIS function, if the PTZ wobble slight when running,
the camera will shield the wobble picture and make the picture calm and smooth.
2.When start-up preset freeze, it can eliminate the sense of flash caused by
calling presets when open function of Preset Freeze, which can reduce the
storage space of DVR if image is stored by DVR.
1.Operate joystick and move to ADVANCE SETTING press OPEN
to enter into "advance setting";
EIS ENABLED Electronic Image Stabilizer function;
PRESET FREEZE Function of Preset Freeze means during
calling presets, the monitor displays the image before call presets, and
releases the freeze image when camera arrives the appointed presets.
HEAD-DOWN : Settings of Top/Down. N means DOWN,
FF means TOP.
DEFOGGER : Lens of PTZ will be fogged when PTZ works in
quite cold temperature. In order to get clear image, defogger will open
automatically at the appointed temperature. Choosing DEFOGGED by
operating the joystick, and press OPEN , then cursor leap to the optional.
Choose the temperature to run the defogger, and press OPEN to save.
Range of Temperature: 0~30 .
ADJ SPEED The rotation percentage of P/T, 100 means factory
speed, 80 means 80% of factory speed.
WIPER : Wiper runs by calling 63 Preset.
MODE : Setting of Infrared light. Call 62 preset to run Infrared light
under the setting of MANUAL . Save 62 preset to close the infrared.
DELAY TIME : Setting the auto close time of IR light, ranging from
1-240 Minutes. IR Cut Filter :Setting the imaging model after the IR light
as ON, three modes for choice: Auto, Color, Black.
ACTIVATE AUX1 Whether to link AUX 1 when open the IR light,
means not to link.
【 】 【 】
【 】
【 】
【 】
【 】
【 】
【 】
【 】
℃
【 】：
【 】
【 】
【 】
【 】
【 】
【 】
,
:
:
“ O ”
“ O ”
“ ON” means Link. “OFF”
LED 1 For LED brightness adjustment, range:50-200, Brightness
increase in proportion as bigger digits is chosen.
LED 2 Same as the above
LED 3 Temporarily unavailable
LIGHT Options of light sources
(Temporarily unavailable)
【 】
【 】
【 】
【 】
System Setting
14
MOTION
AUTO FLIP ON
PROPORTION PAN ON
PARK TIME
005
PARK ACTION SCAN1
POWER UP ACTION AUTO
FAN ENABLED
040
TEMP CENT
BACK
EXIT
ADVANCE SETTING
EIS ENABLED N/A
PRESET FREEZE N/A
IR HEADLIGHT
BACK
EXIT
ADVANCE SETTING
HEAD-DOWN ON/OFF
DEFOGGER 10
A D J SPEED 100
WIPER
IR HEADLIGHT
MODE MID
BACK
EXIT
DELAY TIME 002
BW AUTO
ACT. AUX1 OFF
LED 1 100
LED 2 200
LED 3
LIGHT
×
×
OPERATION KNACKS
【 】
【 】
Auto is invalid as it's searchlight, it must be
controlled under Manual status.