Dimension One Spas Bay Collection - Manual (Page 69)

2004 Bay Collection
Owner’s Manual
Electrical System
Symptom Problem Corrective Action
Will not turn on
– in any mode No power Check circuit breaker and/or GFCI
Turns on by itself Normal automatic daily
power filtration, or anti-
freeze cycle No action required
Light is out Burned out bulb Replace bulb
1. Automatic timer
has shut pump off
1. Push JETS pad again to start another cycle Pump shuts
down
unexpectedly
while in use
2. Motor over-heated
and automatic
protective device
has shut down
pump(s)
2. If pump(s) will not restart when JETS pad is pushed, call for service
Make sure that the equipment panel vent area is not blocked. Vent blockage
can cause serious damage to your equipment.
1. Check water level
2. Clean filter
If problem persists:
1. Turn off power
2. Restart the system
If problem persists:
3 flashing LEDs
appear on the
Top Side Control Possible sensor errors
Call for service
Spa lights always
start in the
default light
sequence Whenever the lights are
turned off they always
turn on in Color Fade
Fast mode Because both lights are synchronized together, they always return to a “common
starting point” after they have been turned off for more than five seconds. This
ensures that they will remain synchronized.
63