Dimension One Spas Bay Collection - Manual (Page 55)

2004 Bay Collection
Owner’s Manual
Routine Equipment Maintenance
Draining Your Equipment
Risk of Accidental Drowning. Extreme caution must be exercised to prevent unauthorized
access by children. To avoid accidents, ensure that children cannot use this system unless they are
supervised at all times.
All models are gravity drained. Do not drain water onto your lawn or plants unless all of the bromine or
chlorine has dissipated from the water. The sanitizer in your water will dissipate quickly by leaving the cover
off and exposing the water to direct sunlight. Drain and replace your water every six months. For heavy water
use, you may wish to change the water more frequently.
You may purchase an optional submersible pump from your dealer or from our Virtual Showroom
at
www.d1spas.com to provide quicker drainage.
Filter Cleaning
Before cleaning the filter element(s), place the spa in the “Standby” mode by pressing the
Dimension One Spas ICON logo, found on the right side of the Top Side Control, for 5-
seconds. You may also shut off the power to the spa by turning off the power at the GFCI.
Your D1 Bay Collection spa is equipped with two top access filter cartridges. We recommend that you clean
the filters monthly as preventative maintenance.
Cleaning the Skimmer Canister
To clean the skimmer filter cartridge, remove the access lid
covering the filter area. Lift the center float of the skimmer
assembly until it is fully extended. Hold the centerpiece of the
assembly and turn it counterclockwise until the flats of the
basket are aligned with the securing tabs. Then pull the basket
assembly straight up to remove. Next, remove the E-Z Lock
Filter cartridge by twisting the cartridge 1/4 turn
counterclockwise to its stop, being careful not to overturn the
filter. Then lift the filter out of its canister. Clean the cartridge
with a high-pressure garden hose. Every other cleaning, soak
the cartridge in a filter cleaning solution, rinse it thoroughly, and
reinstall it. Replace the skimmer basket assembly and the access
lid or cover. Exit the “Standby” mode by pressing Dimension Spas ICON logo for 5-seconds. After cleaning,
run the pump for a few minutes at high speed, then return to the heating mode.
49