Dimension One Spas Bay Collection - Manual (Page 36)

2004 Bay Collection
Owner’s Manual
Spa Check Up
When “SPA CHECK UP” is displayed on the Digital Display Window, we
recommend that you have your hot tub inspected by your dealer as a
preventative maintenance measure.
To reset this message, push and hold the Dimension One Spas
ICON (logo)® Button located at the right hand side of the
control for 3 seconds.
The system can dismiss and reset the maintenance messages by pushing and holding the
Dimension One Spas ICON (logo)®, on the right end of the control, for 3 seconds. If you
press the Dimension One Spas ICON (logo)® for 5 seconds when there is no
maintenance message, it will put the spa in the “Standby” mode.
Overheat
DO NOT ENTER THE WATER when “OVERHEAT” is displayed on
the control system Digital Display Window because the hot tub is in a high
temperature condition. If such a condition exists, check the water
temperature with a certified thermometer and if it is above 104° F (≅40° C),
remove the hot tub cover and allow the water to cool. If the problem recurs,
turn off all power to the hot tub and contact your local Authorized
Dimension One Spas Dealer, or authorized service center
.
The overheat condition could be caused by excessive filtration.
See the
Troubleshooting Guide section for more information.
Flashing Display and/or
“Check Water Level”
DO NOT ENTER THE WATER if you see “3 flashing LEDs” on the
Top Side Control and/or the message, “CHECK WATER LEVEL -CLEAN
FILTER-IF PROBLEM CONTINUES, TURN OFF POWER AND
RESTART THE SYSTEM-IF PROBLEM CONTINUES, CALL FOR
SERVICE” in the Digital Display Window. Follow the instructions as stated.
Check the water temperature and if it is above 104° F (≅40° C) and DO
NOT ENTER THE WATER.
Erroneous Temperature on
the Display
DO NOT ENTER THE WATER if you see a temperature reading of 32°
F (≅0° C) or 136° F (≅57.8° C) without first checking the actual water
temperature with a separate thermometer. The system has detected a
Temperature Probe Failure and the water may be too hot, or too cold, to
safely use.
Contact your local Authorized Dimension One Spas Dealer, or authorized
service center.
30