Dimension One Spas Bay Collection - Manual (Page 62)

2004 Bay Collection
Owner’s Manual
8. Next, check the fittings on the two circulation pumps
located at the bottom of the Lower Equipment
Compartment to make sure they do not leak.
9. Remove the two bleeder valves. One is located in the
skimmer area to the right side of the Top Side Control
and the other one is located across the spa in the
UltraPure™ area on the left side of the Top Side
Control. This will allow air to escape from the pumps.
10. Remove the cap from the UltraPure™
canister and the filter basket from the Weir
Skimmer canister.
UltraPure™/Filter
Weir Skimmer/Filter
11. Remove the foam
blocks securing
each filter.
12. Next, remove the
filters from the Weir Skimmer and the
UltraPure™ canisters and fill your hot tub
by placing a hose into the empty
UltraPure™ canister on the left side of the
Top Side Control (Sarena Bay®) or on the
left side of the fountain (Lotus Bay™).
13. Fill the spa until the water level is slightly below the bottom of the OptiMount® located next to the
Skimmer/Filter Basket on the right side of Sarena Bay® Top Side Control or the bottom of the
Lotus Flowers (located
on the sides adjacent to
the Top Side Control
on the Lotus Bay™).
This is about 6” from
the top of the spa.
56