Altera Signal Integrity Development Kit, Stratix V GX Edition - Manual (Page 12)

3–4 Chapter 3: Software Installation
Installing the USB-Blaster Driver
Transceiver Signal Integrity Development Kit July 2012 Altera Corporation
Stratix V GX Edition User Guide
Installing the USB-Blaster Driver
The Stratix V GX transceiver signal integrity development board includes integrated
USB-Blaster circuitry for FPGA programming. However, for the host computer and
board to communicate, you must install the USB-Blaster driver on the host computer.
f
Installation instructions for the USB-Blaster driver for your operating system are
available on the Altera website. On the
Altera Programming Cable Driver Information
page of the Altera website, locate the table entry for your configuration and click the
link to access the instructions.