Altera Cyclone V SoC - Manual (Page 16)

3–6 Chapter 3: Development Board Setup
Restoring the CFI Flash Device to the Factory Defaults
Cyclone V SoC Development Kit November 2013 Altera Corporation
User Guide
f To ensure that you have the most up-to-date factory restore files and product
information, refer to the
Cyclone V SoC Development Kit page of the Altera website.
Restoring the CFI Flash Device to the Factory Defaults
To program the factory image to the flash device in the Quartus II Programmer, do the
following steps:
1. On the Tools menu in the Quartus II software, click Programmer.
2. In the Programmer window, click Auto-Detect.
1
If you do not see USB Blaster or the board's embedded USB Blaster II listed
next to Hardware Setup, refer to the
“Installing the USB-Blaster II Driver”
on page 2–3 .
3. Click Add File and open
dir>\kits\cycloneVSX_5csxfc6df31_soc\factory_recovery\max2_PFL_writer.po
f.
4. Turn on the Program/Configure option for the .pof file.
5. Click Start to download the selected configuration file to the MAX V CPLD.
Configuration is complete when the progress bar reaches 100%
6. Click Auto Detect and a flash device should show up attached to the MAX V in
the main window.
7. Double-click the graphic of the flash device in the device chain pane to display the
Device’s Properties dialog box.
8. Select the flash image .pof file:
dir>\kits\cycloneVSX_5csxfc6df31_soc\factory_recovery\output_file.pof.
9. Once the flash image .pof is attached in the Quartus II Programmer, turn on
Page_1 and Option Bits. (Page_0 is reserved for the GSRD factory design.)
10. Click Start.
11. After the flash writing process has completed, power cycle the board and look for
the MAX CONF DONE LED to turn ON if successful.
12. Altera recommends that you return to the Max V System Controller factory design
after completing the flash writing. To do so, program the Max V with dir>\kits\cycloneVSX_5csxfc6df31_soc\factory_recovery\max.pof.
For more information, refer to
“Restoring the MAX V CPLD to the Factory
Settings” on page 3–5 .
1 The flash writer version blinks the SEL 2, 1, and 0 LEDs and does not support the
Power Monitor, Clock Control, or other logic functions. Use the flash writer only for
flash programming.
f To ensure that you have the most up-to-date factory restore files and information
about this product, refer to the
Cyclone V SoC Development Kit page of the Altera
website.