Altera Cyclone V SoC - Manual (Page 12)

3–2 Chapter 3: Development Board Setup
Factory Default Switch and Jumper Settings
Cyclone V SoC Development Kit November 2013 Altera Corporation
User Guide
1 The SD card, Max V system controller, and common flash interface (CFI) flash are
already programmed with the factory default files. For more information, refer to
Appendix A, Programming Flash Memory .
To restore the switches to their factory default settings, perform these steps:
1. Set the DIP switch bank (SW2) to match Table 3–1 and Figure 3–1 .
In the following table, ON indicates the switch is to the left according to the board
orientation as shown in
Figure 3–1 .
Figure 3–1. Switch Locations and Default Settings
J5
9V
J13
OSC1_CLK_SEL
J16
J31
I2C
SPI
J26 J27 J28 J29 J30
JTAG_MIC_SEL
J6 JTAG
HPS SEL
J7 JTAG
SEL
SW2
SW3
1 2 3 4
SECURITY
FACT LOAD
Si570
CLK125A
0 1 2 3 4
MSEL
CLKSEL0 CLKSEL1 BOOTSEL0 BOOTSEL1 BOOTSEL2
HPS FPGA HSMC MAX
ON
ON
1 2 3 4 5 6
SW4
JTAG ENABLE
1 2 3 4
ON
SW1
3 2 1 0 3 2 1 0
HPS FPGA
ON
1 2 3 4 5 6 7 8
Table 3–1. SW2 DIP Switch Settings (Part 1 of 2)
Switch
Board
Label
Function
Default
Position
1 CLK125A
Switch 1 has the following options:
■ ON (0) = On-board oscillator is disabled.
■ OFF (1) = On-board oscillator is enabled.
OFF
2 Si570
Switch 2 has the following options:
■ ON (0) = On-board programmable oscillator is
enabled.
■ OFF (1) = On-board programmable oscillator is
disabled.
ON