Altera Remote Update IP Core - Manual (Page 35)

Bit Parameter Width Comments
100 Boot Address —
For the Quartus II software version 13.1 and
onwards:
• Width of 29 or 32 when reading the boot address.
• Width of 24 or 32 when writing the boot address.
• For active serial devices using the 24-bit
addressing, such as EPCS128 or EPCQ128,
boot_
address[23..2]
corresponds to the upper 22 bits
of the 24-bits boot address.
boot_address[1..0]
is read as
2'b0
.
• For active serial devices using the 32-bit
addressing, such as EPCQ256,
boot_
address[31..2]
corresponds to the upper 30 bits
of the 32-bits boot address.
boot_address[1..0]
is read as
2'b0
.
For the Quartus II software version 13.0 or earlier:
• Width of 24 when reading the boot address.
• Width of 22 when writing the boot address.
• Writes the boot address to the upper 22 bits of the
24-bits boot address.
101 Illegal Value
110
Force the internal oscillator
as startup state machine
clock (osc_int) option bit
1 —
111 Reconfiguration trigger
conditions (Read Only)
5
Bit 4 (
nconfig_source
)—external configuration reset
(
nconfig
) assertion.
Bit 3 (
crcerror_source
)—CRC error during
application configuration.
Bit 2 (
nstatus_source
)—
nstatus
asserted by an
external device as the result of an error.
Bit 1 (
wdtimer_source
)—User watchdog timer
timeout.
Bit 0 (
runconfig_source
)—Configuration reset
triggered from logic array.
Remote Update Operation
Note:
read_source
specifies whether a parameter value is read from the current or a previous state. For
more information, refer to Table 14 .
Note: Perform remote update operations in the corresponding master state machine (MSM) mode.
UG-31005
2015.04.07
Remote Update Operation 35
Altera Remote Update IP Core User Guide Altera Corporation
Send Feedback