Pilz PSSu E F PS2 - Manual (Page 21)

Wiring
Operating Manual PSSu E F PS2(­T)(­R)
1002237­EN­03 21
} On base modules with screw terminals:
– If you use a multi­strand cable to connect the I/Os, it is recommended that you use
ferrules conforming to Parts 1 and 2 of DIN 46228, 0.14 ... 1.5 mm
2 , Form A or C,
although this is not essential. To crimp the ferrules you can use crimp pliers (crimp
form A or C) conforming to EN 60947­1, such as the PZ 1.5 or PZ 6.5 from
Weidmüller, for example.
– Maximum torque setting: 0.8 Nm
} Use copper wiring.
6.2 Terminal configuration
} For use as a supply module to refresh the module supply and periphery supply
} For use as a supply module to form supply groups
– To interrupt the incoming periphery supply and C­rail
– To provide subsequent modules with the module supply, periphery supply and C­
rail supply
Base module Terminal configuration
Screw terminals:
PSSu BS­R 2/8S
PSSu BS­R 2/8S­T
Cage clamp terminals:
PSSu BS­R 2/8C
PSSu BS­R 2/8C­T
11: +24 V infeed for module
supply,
interrupted to the left
21: 0 V infeed for module
supply
12 ­22: 0 V Periphery Sup­
ply,
interrupted to the left
(12­22 linked within the base
module)
13 ­23: +24 V periphery sup­
ply, interrupted to the left
(13­23 linked within the base
module)
14­24 C­rail supply,
interrupted to the left
(14­24 linked within the base
module)
21 11
22 12
23 13
24 14