Pilz PNOZ mmc1p ETH - Manual (Page 25)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-1
7.1 Messages
7 Operation
7 7000 Operation Operation 7- 7.1 Messages 7100 Messages 7- Betrieb_Meldungen_allgemein_BA
When the supply voltage is switched on, the PNOZmulti safety system
copies the configuration from the chip card.
The LEDs "POWER","DIAG", "FAULT", "IFAULT" and "OFAULT" light up
on the base unit.
Betrieb_Meldungen_Kommunikationsmodul_BA
The safety system PNOZmulti is ready for operation when the "POWER"
and "RUN" LEDs on the base unit and the "POWER" LED on the
PNOZ mmc1p are lit continuously.
7.1.1 Display elements for device diagnostics
Display elements for device diagnostics 7- Anzeige Legende 3x
Key:
Betrieb_Anzeige_Kommunikationsmodul_Ethernet_BA
LED on
LED flashes
LED off
LED LED status Meaning
Power No supply voltage
Green Supply voltage is present
Link1 No network connection at Link1
Green Network connection available at Link1
Link2 No network connection at Link2
Green Network connection available at Link2
Traffic1 No data traffic at Link1
Yellow Data traffic available at Link1
Traffic2 No data traffic at Link2
Yellow Data traffic available at Link2