Toreduce the risk of severe injury or death, Important installation instructions, Safe-t-beam – Genie Pro max PMX-IC B Series User Manual
Page 4: Stb) non-contact reversing system, Safe-t-reverse, Contact reversing system, Safe-t-stop, Timed reversed system, Force guard, Control
![background image](/manuals/743807/4/background.png)
4
Garage doors are large, heavy objects that move with the help of springs
under high tension and electric motors. Since moving objects, springs under
tension, and electric motors can cause injuries, your safety and the safety of
others depend on you reading the information in this manual. If you have
questions or do not understand the information presented, call your nearest
service representative
In this section and those that follow, the words
Danger,Warning,
and
Caution
are used to emphasize important safety information.
The word:
DANGER
means that severe injury or death will result from failure
to follow instructions.
WARNING
means that severe injury or death can result from failure
to follow instructions.
CAUTION
means that property damage or injury can result from failure
to follow instruction.
The word
NOTE
is used to indicate important steps to be followed
or important considerations.
OVERVIEW OF
POTENTIAL HAZARDS
POTENTIAL
HAZARD
EFFECT
PREVENTION
Keep people clear of opening while door is
moving.
Do Not
allow children to play with the door
operator.
Do Not
operate a door that jams or one that
has a broken spring.
MOVING
DOOR
WARNING:
Can Cause
Serious Injury
or Death
Turn off power before removing operator cover.
When replacing cover, make sure wires are not
pinched or near moving parts.
Operator must be properly grounded.
ELECTRICAL
SHOCK
WARNING:
Can Cause
Serious Injury
or Death
Do Not
try to remove, repair or adjust springs
or anything to which door spring parts are
fastened, such as, wood blocks, steel
brackets, cables or other like items.
Repairs and adjustments must be made by a
trained service person using proper tools and
instructions.
HIGH
SPRING
TENSION
WARNING:
Can Cause
Serious Injury
or Death
Safe-T-Beam
®
(STB) Non-Contact Reversing System
Places an invisible beam across door opening that reverses the door during down travel to the fully open
position if anything passes through beam
Safe-T-Reverse
®
Contact Reversing System
Automatically stops and reverses a closing door within 2 seconds of contact with an object
Safe-T-Stop
®
Timed Reversed System
Automatically opens a closing door if door does not close within 30 seconds
Force Guard
®
Control
Used to set the force required for opening and closing door For maximum safety set the minimum force
required to fully open and close door
Automatic Lighting System
One or two light bulbs (depending on model) up to 100 Watts max each are used for safer entries and exits
The light turns on when door is activated and automatically turns off 4 5 minutes later
Manual Emergency Release
Allows the garage door to be opened or closed manually for emergencies or maintenance
IMPORTANT
INSTALLATION
INSTRUCTIONS
1. READ AND FOLLOW ALL SAFETY, INSTALLATION AND
OPERATION INSTRUCTIONS. If you have any questions or
do not understand an instruction, call your service
representative.
2. Do Not install operator on an improperly balanced door. An
improperly balanced door could cause severe injury. Repairs
and adjustments to cables, spring assembly, and other
hardware must be made by a trained service person using
proper tools and instructions.
3. Remove all ropes and disable all locks connected to the
door before installing operator.
4. Install door operator 7 feet or more above the floor. Mount
the emergency release knob 6 feet above the floor.
5. Do Not connect the operator to the source of power until
instructed to do so.
6. Locate the control button:
• Within sight of door.
• At a minimum height of 5 feet, so small children cannot
reach it.
• Away from all moving parts of the door.
7. Install the entrapment WARNING label next to the wall
button or console. Install the emergency release tag on, or
next to, the emergency release
8. The operator must reverse when the door contacts a 1-1/2
inch high object on the floor at the center of the doorway.
This is about the size of a 2” x 4” board laid flat.
Toreduce the risk of
severe injury or death:
W
WAAAARRNNNNIINNNGGGG
::
SAAFETTYY INNFORRMAATIOONN
OPERRATOR IINNSTTAALLLLAATTIION
SSAAAFFEETTYY FFEEAATTTTUUURRREESS
((((vvvvaaaarrrriieess bbyy mmooddddeell))