Fig. 10-1), Attach visor clip to remote control (fig. 10-2), Remote control operation – Genie Pro max PMX-IC B Series User Manual
Page 25: Program multi-button remote control, Your remote control is battery powered), Gently push straight in on tab as shown, Use ball point pen, coin or small screwdriver, Battery cover snaps open, Install new battery in same position, Use a23, 12 volt battery
1. Turn remote control upside down (Fig. 10-1)
2. Battery replacement
(your remote control is
battery powered).
•
Gently push straight IN on tab as shown
(Fig. 10-1).
–
use ball point pen, coin or small screwdriver.
–
battery cover snaps open.
•
Install new battery in same position.
–
use A23, 12 Volt battery.
3. Attach visor clip to remote control (Fig. 10-2)
•
Slide visor clip into back of case until it snaps
into place.
4. Remote control operation
•
Point remote control at the garage door and
press the button. Door will move.
•
Press remote control button again and door
will stop.
•
Press remote control button again and the door
will move the other way.The door automatically
stops at the end of the open or close cycle.
Fig. 10-1
Fig. 10-2
Visor clip
Battery
Battery
cover
+
–
Fig. 9-1
Learn
code
button
Radio
signal
indicator
M RE
ORE
IM T AD US MENT
LO E
O EN
PU H
IM TS
TO SET
CLA S 2
N C
N C
LASS 2
1
2
3
4
5
6
M RE
RC
SH
T O
F T
AM
M T
E
R
O
R
D
A
N
D
M
NO E
U E N
W H
S R
O
O
CLO E
MORE
PEN
ORE
CLOS
PEN
LIMIT ADJUSTMENT
U S P t
t N
5
43 7 4
5 2 1 869
STEALTH
PRO-MAX
•
Press and release a remote control button.
–
LED on power head stops blinking.
•
Press and release same remote button again.
–
LED goes out. Remote is now programmed.
2. Program multi-button remote control
•
Repeat step 1 (“program one-button remote” for
each button).
NOOTE: Eacch butttoonn oonn aa multi-button remote ccontrol
is ffoorr aa differeent ooppeerattoorr..
3. Operate remote control
•
Point remote control at door
–
Door moves
•
Press button again
–
Door stops
•
Press button again
–
Door reverses
NOOTE: Dooorr automattiicallly sstops att eend of open or
cloose cyclee.
4. Erasing all receiver memory
•
Press and hold learn code button on
power head
–
10 seconds or until light goes out
–
Memory is erased
•
Program door operator again
•
Press remote control button once within
30 seconds
–
LED on power head stays lit
•
Press remote control button again
–
LED on power head goes out and remote
control is programmed
NOOTE: Iff LEDD bliinkss approoxximatteely 4 timmees ppeer
seccond, pprrooggrraamminngg hhaas sstopped. IIf pprogrammmiing
stops,, reppeeatt above ssteppss.
Radio
signal
indicator
Learn
code
button
25
1100
......
BBAATTTTTTEERRRRYYYY //// VVVVIISSOOOORR CCCLLLIIPPP IIIINNNNSSSSTTAAAALLLLLLAAAATTTTIIOONNNN