Genie Pro max PMX-IC B Series - Manual (Page 12)

WARNING
•
Do Not try to remove, repair or adjust
springs or anything to which door spring
parts are fastened, such as, wood blocks,
steel brackets, cables or other like items.
Repairs and adjustments must be made by
a trained service person using proper tools
and instructions.
•
Handles and other door projections can
catch clothing. Remove ropes, hooks,
hangers, decorative or security items
mounted to door.
•
Be sure Emergency Release Cord does not
catch on roof carrier or other vehicle parts.
1. Establish center line of door and header (Fig. 2-1).
•
Close door.
•
Measure door width. Mark center.
•
Use straight edge to draw vertical line
“
V.
”
–
down door about 6
”
.
–
on top of door.
–
up header about 20
”
.
2. Establish Header Bracket position (Fig. 2-2).
•
Watch top edge of door as you raise it.
•
Stop door when top edge reaches highest point
of travel.
•
Measure distance from top edge of door to floor.
•
Add 2-1/2
”
to this measurement.
•
Close door.
•
Mark header at this height.
•
If door spring is in the way, mark header 2-1/2
”
above the spring.
•
Draw horizontal line
“
H
”
across line
“
V
”
at this
point (Fig 2-1).
NOTE: Heaaderr bbrraackket muusst be att lleaast 2--11/2
”
abovee
high poinntt of door travvel.. IIt cann bbee insttaalleed higherr iiff
door spprriing is iin the waay.. Doo NNott moovve the ssprinngg..
Fig. 2-2
Door
Header
Line
“
H
”
Line
“
H
”
Can Be
Drawn Above
Spring
Fig. 2-1
Line
“
V
”
(Vertical Center Line
of Door)
Inside of Door
AAlltteernatee Mouuntingg Meethodds
NOTE: Materials for mounting are not included
Angle Iron Method Conduit Method
Spring
Door Track
Add 2-1/2
” Minimum
Measure To Floor
High Point
Of Door Travel
Mark
Header
Here
Or
Above
Spring
Header
NOTE: Line
“
H
”
Can Be
Drawn Above Spring
Door
Line
“
H
”
2222AAAA
...
FFORR TRRAACCKK GUUIIDDEED DDOOORRSS
12
– FOR TRACKLESS DOORS GO TO PAGE 15 –