Ubiquiti Networks Rockeac - Manual (Page 17)

14
Chapter 3: Wireless airOS®7 User Guide
Ubiquiti Networks, Inc.
WPA Authentication Specify one of the following WPA
key selection methods:
•
PSK Pre-shared Key method (selected by default).
• EAP EAP (Extensible Authentication Protocol)
IEEE 802.1x authentication method. This method is
commonly used in enterprise networks.
PSK
WPA Preshared Key Specify a passphrase. The preshared
key is an alpha-numeric password between 8 and 63
characters long.
Show Click Show if you want to view the characters of the
WPA Preshared Key.
EAP
Available options depend on the wireless mode, as follows:
EAP - Access Point PTP or Access Point PTMP Mode
The options below apply in Access Point PTP or Access Point
PTMP mode only.
Auth Server IP/Port In the first field, enter the IP
address of the RADIUS authentication server. RADIUS is a
networking protocol providing centralized Authentication,
Authorization, and Accounting (AAA) management for
computers to connect to and use a network service.
In the second field, enter the UDP port of the RADIUS
authentication server. The most commonly used port is
1812, but this may vary depending on the RADIUS server
you are using.
Auth Server Secret Enter the password. A shared
secret is a case-sensitive text string used to validate
communication between two RADIUS devices.
Show Click Show if you want to view the characters of the
Auth Server Secret.
Accounting Server If you are using an accounting server,
select this option.
Accounting Server IP/Port If the Accounting Server is
enabled, enter the IP address of the accounting server.
In the second field, enter the UDP port of the RADIUS
accounting server. The most commonly used port is 1813,
but this may vary depending on the RADIUS server you
are using.
Accounting Server Secret If the Accounting Server is
enabled, enter the password. A shared secret is a case-
sensitive text string used to validate communication
between two RADIUS devices.
Show Click Show if you want to view the characters of the
Accounting Server Secret.
EAP - Station PTP or Station PTMP Mode
The options below apply in Station PTP or Station PTMP
mode only.
EAP Type Select the authentication protocol (EAP-TTLS
or EAP-PEAP) and the inner authentication protocol
(MSCHAPV2).
WPA Anonymous Identity Enter the identification
credential used by the supplicant for EAP authentication
in unencrypted form.
WPA User Name Enter the identification credential used
by the supplicant for EAP authentication.
WPA User Password Enter the password credential used
by the supplicant for EAP authentication.
Show Click Show if you want to view the characters of the
WPA User Password.
Signal LED Thresholds
You can configure the LEDs on the device to light up
when received signal levels reach the values defined in
the following fields. This allows a technician to easily
deploy an airOS 7 CPE without logging into the device (for
example, for antenna alignment operation).
Thresholds, dBm The number of LEDs is device-specific,
and the default values vary depending on the number of
LEDs. The specified LED will light up if the signal strength
reaches the value set in the field.
For example, if the device has four LEDs and the signal
strength (on the Main tab) fluctuates around -63 dBm,
then the LED threshold values can be set to the following:
-70, -65, -62, and -60.