Appendix e ses/saf-te host connection, Figure e-1: jumper j3 location – StorCase Technology DS500 User Manual

Page 72

Appendix E SES/SAF-TE Host Connection

Kingston Technology Company

RemotaSilo User’s Guide - Rev. B00

Appendix E SES/SAF-TE Host
Connection

The RemotaSilo software monitoring system supports the SCSI-3
Enclosure Services (SES) or the SCSI Accessed Fault-Tolerant
Enclosures (SAF-TE) command set. This feature allows chassis
monitoring to the host PC through a SCSI cable instead of a serial port
connection. A SCSI cable is provided in your RemotaSilo package to
connect the DS500 chassis to an 8-bit SCSI controller installed in the
Host PC. This section explains the steps involved in setting up the
SES/SAF-TE host connection.

Jumper J3

First, Jumper J3 must be set on the RemotaSilo circuit board. Jumper
J3 is a 10-pin header connector used for setting the SCSI ID number
and enabling or disabling on-board SCSI termination. See Figure E-1
below for the jumper location:

Pin 1

50-Pin
Header
Connector

Pin 1

Pin 2

Jumper J3

DB-9
Serial
Connector

BNC
Connector

0806

Figure E-1: Jumper J3 Location

Jumper J3