StorCase Technology DS500 - Manual (Page 20)

16 Hardware Installation
Kingston Technology Company RemotaSilo User’s Guide - Rev. B00
Chassis ID Conflict
When the dot (.) of the left side LED display is ON solid, this indicates
that the RemotaSilo chassis ID number selected by the user is in
conflict with an ID currently being used by another RemotaSilo chassis.
RemotaSilo Activity
When the “f” segment of the left-hand 7-segment display LED is blinking
(at approximately 2 Hz), this indicates that the RemotaSilo chassis has
already passed the power-on diagnostic test and is currently active.
Push Switches
There are two push switches located on the top of the RemotaSilo 7-
segment display LEDs. The left-hand switch, when pressed and
released, resets all electronics on the RemotaSilo circuit board. The
right-hand switch is only effective if the RemotaSilo chassis is in the
stand-alone mode and is not communicating with the host computer
(see stand-alone mode above). If the right-hand switch is pressed and
released, the RemotaSilo chassis ID number will be incremented by
one. When the display value reaches 15, the digits will cycle back to 0.
Left-Side Push Switch
Performs Reset Right-Side Push Switch
Toggles Stand Alone Mode
Stand-Alone Mode is ON
when light is solid
0805
Figure 8: Push Switch Functions