StorCase Technology DS500 - Manual (Page 56)

52 Appendix C Software Features
Kingston Technology Company RemotaSilo User’s Guide - Rev. B00
Chassis / Reset Alarm
The alarm indicator on the front of a RemotaSilo chassis will blink when
an alarm condition occurs due to chassis temperature, fans or power
supply(s). This command resets the alarm signal and stops the blinking
indicator. This command is intended for use after the cause of the
alarm has been acknowledged by the operator.
Chassis / Sound Control
A RemotaSilo chassis alarm condition also invokes an audible alarm,
unless the audible alarm is disabled. The sound control command is
used to toggle the sound enable on the selected RemotaSilo chassis.
Select either Yes/No to enable/disable, depending on the current state
of the audible alarm.
Chassis / Online Indicator / E nable
This command turns on the blinking LED on the front of the selected
RemotaSilo chassis.
The blinking LED indicates that the monitoring board is operating
normally. If the online indicator is enabled, and the LED does not blink,
the RemotaSilo circuit board may have failed.
Chassis / Online Indicator / D isable
This command turns off the blinking LED on the front of the selected
RemotaSilo chassis.