Spectrum Controls 1769sc-HART Modules - Manual (Page 19)

User's Manual 0300215-03 Rev. A
Chapter 3
Installation and Wiring
This chapter explains how to:
•
Determine the power requirements for the module
•
Avoid electrostatic damage
•
Install the module
•
Wire the module’s terminal block
•
Wire input devices
Section 3.1
Compliance to
European Union
Directives
This product is approved for installation within the European Union and EEA regions. It
has been designed and tested to meet the following directives.
3.1.1 EMC Directive
The 1769sc-IF4IH module is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards, in whole or in part,
documented in a technical construction file:
•
EN 50081-2 EMC – Generic Emission Standard, Part 2 - Industrial Environment
•
EN 50082-2 EMC – Generic Immunity Standard, Part 2 - Industrial Environment
This product is intended for use in an industrial environment.
3.1.2 Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage, by applying
the safety requirements of EN 61131-2 Programmable Controllers, Part 2 – Equipment
Requirements and Tests. For specific information required by EN61131-2, see the
appropriate sections in this publication, as well as the following Allen-Bradley
publications:
•
Industrial Automation, Wiring and Grounding Guidelines for Noise Immunity,
publication 1770-4.1
•
Automation Systems Catalog, publication B113
3.1.3 CE Safety
This product is designed to, and verified compliance with, European Union Safety
Standards:
•
EN61131-2
•
EN61010-1