SOR Calibration Manager Software - Manual (Page 5)

5/12 Form 1459 (01.13) ©SOR Inc.
NOTE: It is recommended to disconnect from a device before you exit the
application or unclip/disconnect any Calibration Interface leads.
When you have successfully connected to a device, the form title text will show “SOR
Calibration Manager – Connected”. The application window will automatically be
updated with configuration information about the device, such as the product name,
product model, unit serial number, signal output type (4-20mA or 1-5V), and the
calibrated Zero and Span Set Points for that device. For the 805QS, the switch output
settings will also be displayed.
The main calibration manager window will be displayed differently based on the type of
product being calibrated as followed:
805PT
Pressure
Transmitter
805QS
Pressure
Switch
NOTE: Units that have been calibrated using a previous version of the SOR Calibration
Manager will need to be re-calibrated to display the calibrated Zero and Span Set Points.
NOTE: The software will display warnings for 805QS units that have not been previously
calibrated on the user’s PC. These warnings are not displayed once a unit’s switch output
has been calibrated or verified.