SOR 805PT Pressure Transmitter - Manual

Form 1435 (10.13) ©SOR Inc. 1/8
805PT Pressure Transmitter
General Instructions
These instructions provide information for installation, process
connection, electrical connection, operation and maintenance of
805PT Pressure Transmitters. The 805PT Pressure Transmitter
consists of a field proven sputtered thin film stainless steel
pressure transducer and a reliable electronic circuit. The housing
features a stainless steel construction.
The 805PT is capable of powering long cable lengths. See Formula
on page 3 for maximum loop resistance.
NOTE: If you suspect that an instrument is defective, contact the factory
or the SOR
® representative in your area for a return authorization
number (RMA). This product should only be installed by trained and
competent personnel.
Registered Quality System to ISO 9001
Design and
specifications are
subject to change
without notice.
For latest revision, go to
sorinc.com
Table of Contents
Installation .......................................1
Additional Install Steps for Dual Seal Units....2
Electrical Termination - 805PT-C .............3
Electrical Termination - 805PT-V .............4
Operation.........................................5
Dimensions ......................................5
Maintenance .....................................6
ATEX Marking Details ..........................6
Declaration of Conformity .....................7
Installation
Ensure that wiring conforms to all applicable local and national electrical codes and install
unit(s) according to relevant national and local safety codes.
Normally, line mounting provides adequate support for the instrument.