Rocktron MIDI Raider - Manual (Page 67)

64
CUSTOM, Page 2 of 2 - Additional Data
some MIDI commands selected in CUSTOM, Page 1 will have a “>”
symbol following the command name. This symbol indicates MIDI
commands that require additional data which needs to be programmed
before the message can be stored in memory. For example, the “note
Off>” command requires information concerning the MIDI Channel,
note number and note Velocity, as shown in the example below. The
second page of the CUSTOM program allows for the selection of this
additional information.
To define additional MIDI information:
() Press the "" switch to access the second page of the CUSTOM
program. (If the MIDI raider is not already in the CUsTOM
editing mode, press “2nD”, then “CUsTOM”, followed by “".)
() Use the "InC" and "DeC" switches directly below the left side
of the display to edit the information shown on the left side of the
display.
() Use the "InC" and "DeC" switches directly below the center
of the display to edit the information shown in the center of the
display.
() Use the "InC" and "DeC" switches directly below the right side
of the display to edit the information shown on the right side of
the display.
MIDI Commands not followed by the “>” symbol do not require
the additional data shown in CUSTOM, Page 2.