Rocktron MIDI Raider - Manual (Page 25)

22
SETUP, Page 7 of 10 - MIDI Filtering
The seventh page of the seTUP program, MIDI Filtering, allows
for incoming MIDI signals to either be merged with the footswitch’s
MIDI information or selectively blocked. Filtering may be done either
by message type or by MIDI channel.
To change the MIDI filtering status:
() With the 2nD l.e.D. still lit, press the "" switch to access
the seventh page of the seTUP program. (If the MIDI raider
is not already in seTUP mode, press "2nD", then "seTUP",
followed by "" six times.)
() To select a MIDI channel or message type to edit, use the
"InC" and "DeC" switches directly below the MIDI channel
currently displayed.
() To change the status of the MIDI channel or message type cur-
rently displayed, use the "InC" and "DeC" switches directly
below the displayed status.
MIDI Message Abbreviations:
some of the MIDI messages displayed in the MIDI Filtering page
are abbreviated to fit on the screen. Here is a list of those that are
abbreviated.
KeY PressUre (Key Pressure)
CTr CHanGe (Control Change)
PrOG CHanGe (Program Change)
CHan PresUr (Channel Pressure)
sYTeM eXCls (system exclusive)
MTC (MIDI Time Code)
sOnG PP (song Position Pointer)
TUne reQesT (Tune request)
TIMnG ClOCK (Timing Clock)
aCTIVe sense (active sensing)
sYsTeM rsT (system reset)