Rocktron MIDI Raider - Manual (Page 15)

12
SETUP, Page 2 of 10 - Bank Size
The second page of the seTUP program allows for the selection of the Bank
Size, or the number of presets that the MIDI raider will bank up or down by
when the UP or DOWn switches are pressed.
When set to “5”, switches 1-5 become preset switches and the unit will bank
up or down by 5 presets at a time. When set to “10”, switches 1-10 become
preset switches and the unit will bank up or down by 10 presets at a time.
When set to “15”, switches 1-15 become preset switches and the unit banks
up or down by 15 presets at a time. When set to “1”, the unit banks up or
down by one preset at a time and all of the switches become instant access
switches.
The Bank size setting also determines the number of preset switches for each
song when operating the MIDI raider in song mode.
About Preset and Instant Access Switches:
The MIDI Raider can be configured so that one row (switches 1-5), two rows
(switches 1-10) or three rows (switches 1-15) of switches can be dedicated as
preset switches, or switches that are used to select the various presets within
each bank. Preset switches send out commands which can reconfigure a
whole rack.
Any switches that are not configured as preset switches automatically become
instant access switches - or switches that are used to send specific MIDI
controller information on specific MIDI channels. Instant access switches
are used to switch in or out a specific effect or function on a MIDI receiving
device - thereby giving the user direct control over that specific effect or
function without affecting other effects, functions or presets within a rack of
devices.
Instant access switches can operate globally or per preset (see Setup, Page 4),
and each can be configured to operate as a latching, momentary or hold type
switch. (To configure instant access switches, refer to MIDI, Pages 2-4.)
To Select the Bank Size:
() With the MIDI raider still in seTUP mode (2nD and seTUP l.e.D.s
lit), press the “" switch to access the second page of the seTUP pro-
gram, Bank Size. (If the MIDI raider is not already in seTUP mode,
press “2nD”, then “seTUP”, followed by “" one time.)
() To select a new bank size, press the "InC" or "DeC" switches directly
below the currently selected option to scroll through the available
selections.