Rocktron MIDI Raider User Manual
Page 19
16
SETUP, Page 4 of 10 - Instant access switch
operating status
The fourth page of the seTUP program determines whether the
controller values sent from the MIDI raider are global (the same
for all presets) or set on a per preset basis. When set to “GlOBal”,
the controller channel, control number, “on” value and “off” value
that is sent when an instant access switch is pressed is the same for
all presets. When set to “Per Pr”, the controller channel, control
number, “on” value and “off” value that is sent when an instant access
switch is pressed can be programmed for each individual preset.
To change the instant access switch operating status:
() With the 2nD l.e.D. still lit, press the "" switch to access
the next page of the seTUP program. (If the MIDI raider is
not already in seTUP mode, press "2nD", then "seTUP", fol-
lowed by "" three times.)
() To select a specific instant access switch, use the "INC" and
"DeC" switches directly below the currently selected switch.
The current setting for each switch or pedal will be displayed.
() To select whether the displayed switch is configured as
"GlOBal" or "Per Pr", use the "InC" and "DeC" switches
directly below the currently displayed option.
Note:
When scrolling through the
switches to program, only
those switches which are
configured as instant access
switches can be accessed.