Rocktron MIDI Raider - Manual (Page 31)

28
SETUP, Page 10 of 10 - Remote Title Number
The tenth page of the seTUP program is Remote Title Number. By
matching the remote title number with that of another rocktron
product, the titles from the other rocktron unit will be transmitted to
the MIDI raider and displayed when operating in reMOTe mode.
To select a remote title number:
() With the 2nD l.e.D. still lit, press the "" switch to access
the tenth page of the seTUP program, Remote Title Number.
(If the MIDI raider is not already in seTUP mode, press
“2nD”, then “seTUP”, followed by “" nine times.)
() To select a remote Title number, use the "InC" and "DeC"
switches directly below the number currently displayed.
Remote mode notes:
When operating the MIDI
Raider in remote mode with a
Rocktron rack unit, changes
made from the rack unit
itself will be reflected on the
footswitch. For example, if
button 6 on the MIDI Raider is
configured to control the Delay
In/Out parameter on the rack
unit, switching out the delay
from the rack unit instead of
the MIDI Raider will cause
the L.E.D. for button 6 on the
footswitch to turn off.
In addition, when a preset is
changed from the rack unit,
the rack sends the status of
its mapped parameters to
the MIDI Raider, causing the
corresponding L.E.D.s to turn
on or off to reflect the proper
status.
In Remote mode, control
changes are not sent when an
MIDI Raider preset switch is
pressed, as the status of the
instant access switches will be
determined by the rack unit.