Martin Christ RVC 2-25 CDplus - Manual (Page 32)

RVC 2-25 CD&
6 Operation
32
Version 11/2008, Rev. 2.2 of 04/12/2013 • sb
Translation of the original operating manual
Pos: 111 /20 0 Ch rist/3 70 RVC-BA (S TANDARDMODULE) /06 0 Betri eb/0 60 Bet rieb == == === == == === == == === == == === == == == === == = @ 8\mo d_1 309 426 563 173 _68. docx @ 46 735 @ 1 @ 1
6 Operation
Pos: 112 /20 0 Ch rist/3 70 RVC-BA (S TANDARDMODULE) /06 0 Betri eb/0 60- 001 0 Ers te In bet rieb nah me+ ++ ++ +++ ++ ++ +++ ++ ++ +++ ++ ++ @ 8\ mod _13 094 265 6354 8_6 8.d ocx @ 4674 3 @ 2 @ 1
6.1 Initial start-up
WARNING
Before the initial start-up, please ensure that your RVC is properly set up
and installed (see chapter 5 - "Set-up and connection")
Pos: 113 /01 0 Univ ersal mod ule/ Lee rzeile @ 0\ mo d_12 021 162 445 00_ 0.doc x @ 1 14 @ @ 1
Pos: 114 /20 0 Ch rist/3 70 RVC-BA (S TANDARDMODULE) /06 0 Betri eb/0 60- 002 0 Einsc halte n+ +++ ++ ++ +++ ++ ++ +++ ++ ++ +++ ++ ++ ++ +++ ++ ++ @ 8\ mod _13 0942 656 454 8_6 8.doc x @ 4 676 7 @ 2 @ 1
6.2 Switching the RVC on
• Press the mains power switch on the right-hand side of the unit.
The CD
plus
control unit performs a self-test and an initialisation. This may
take several seconds.
• Follow the safety instructions and hazard warnings !
Pos: 115 /01 0 Univ ersal mod ule/ Lee rzeile @ 0\ mo d_12 021 162 445 00_ 0.doc x @ 1 14 @ @ 1
Pos: 116 /20 0 Ch rist/3 70 RVC-BA (S TANDARDMODULE) /06 0 Betri eb/0 60- 003 0 Ö ffne n un d Schlie ßen des D eckels @ 8\ mod _13 094 270 445 54_6 8.d ocx @ 467 91 @ 2 @ 1
6.3 Opening and closing the lid
The lid can be opened if the rotor chamber is aerated and if the rotor is at a
standstill. The rotational vacuum concentrator cannot be started if the lid is
open.
• Select "mode" with the left-hand function key.
• Select "Open lid" with the up and down keys.
• To close, press slightly on the lid until both locks are locked.
DANGER
Do not place your fingers between the lid and the housing when closing
the lid. Risk of crushing!
Pos: 117 /01 0 Univ ersal mod ule/ Lee rzeile @ 0\ mo d_12 021 162 445 00_ 0.doc x @ 1 14 @ @ 1
Pos: 118 /01 0 Univ ersal mod ule/ Lee rzeile @ 0\ mo d_12 021 162 445 00_ 0.doc x @ 1 14 @ @ 1
Pos: 119 /20 0 Ch rist/3 70 RVC-BA (S TANDARDMODULE) /06 0 Betri eb/0 60- 004 0 Eins etzen von R oto ren und Zu beh ör- -- --- -- --- --- -- --- -- --- -- --- --- -- --- - @ 8\m od_ 1309 498 541 224 _68. docx @ 46 808 @ 2 @ 1
6.4 Installation of rotors and accessories
Pos: 120 /01 0 Univ ersal mod ule/ Lee rzeile @ 0\ mo d_12 021 162 445 00_ 0.doc x @ 1 14 @ @ 1
Pos: 121 /20 0 Ch rist/3 70 RVC-BA (S TANDARDMODULE) /06 0 Betri eb/0 60- 004 0-0 010 Einsetz en v on Wink elrot ore n @ 8\m od_ 130 9496 686 889 _68. docx @ 46 801 @ 3 @ 1
6.4.1 Installation of angle rotors
• Only use inserts that are suitable for the rotor (see chapter 11.2 -
"Rotor program").
• Always load the opposite inserts of the rotors with the same accessories
and fill to avoid imbalance.
• Push the loaded rotor onto the rotor shaft until it reaches the stop.