Labconco WaterPr BT Systems 90153 Series - Manual (Page 27)

Installation
19
Hydrating the System
• At this time, the Final Filter is not installed. Leave the system
overnight or for several hours in FILLING TANK mode or PRE
OPERATE mode (see
Section Operating Modes ). The system will
regularly recirculate water and rinse off purification media inside
the Filter Pack cartridge. Do not leave the system in STANDBY
mode.
• (The next morning) Press the Dispensing Button once to put the
system into DISPENSING mode.
• Allow about 1 L of water to be dispensed from the system.
• Press the Dispensing Button once again. The system will finish
dispensing water.
• Remove the Clear Tubing and the Barbed Fitting from the POU
Dispenser.
• The Final Filter needs to be installed. See Section Installation and
Rinsing of the Final Filter.