Labconco WaterPr BT Systems 90153 Series - Manual (Page 24)

Installation
16
Rinsing the Filter Pack cartridge
J • Let FILLING TANK mode run for a minimum of 2 hours with the Tank
Outlet Valve open and placed to the drain. This will completely rinse
the purification media inside the Filter Pack cartridge.
NOTE: For sensitive applications, it is recommended to leave the
system in FILLING TANK overnight to ensure complete rinsing of the
RO membrane.
• Close the Tank Outlet Valve (J) and connect it back to the system if
needed. The tank will start to fill up with water. It could take
approximately 1.5 to 2 hours to fill the tank. When it is full, the
Display will indicate a full tank by illuminating the symbols
representing the Tank Level
(see Section Understanding the Display) .
• The Vent Filter needs to be installed (see Section Installation of the
Vent Filter) .