EXFO FPM-600 Power Meter - Manual (Page 28)

Measuring Power or Loss (FPM-600 and FOT-600)
22 FPM/FLS/FOT-600
Defining a List of Favorite Wavelengths
Defining a List of Favorite Wavelengths
You must put the wavelengths you want to use on a list of favorite
wavelengths (the FAV list). Only wavelengths on this list are available for
measurements. You may enter up to 40 favorite wavelengths.
Specifications are guaranteed for calibrated wavelengths only. For other
wavelengths, the unit will determine values based on the calibrated
wavelengths (3-point interpolation).
To add wavelengths to the FAV list (or to remove them):
1. From normal operating mode, press
repeatedly until you reach PM.
2. Press to access the first submenu, then
press repeatedly until you reach the FAV
menu.
3. Press to switch between available wavelengths. An asterisk ( *)
appears beside wavelengths already on the list. If no wavelength is set
for a position, the unit indicates “----”. You may also press
to
switch between defined wavelengths only.
Detector
Type
Calibrated
Wavelengths (nm)
Default Favorite
Wavelengths a (nm)
a. To revert to default favorite wavelengths see Reverting Unit to Factory Settings on
page 56.

Ge 800, 820, 830, 840, 850, 860, 870, 880,
910, 980, 1270, 1280, 1290, 1300,
1310, 1320, 1330, 1340, 1350, 1370,
1390, 1410, 1430, 1450, 1460, 1470,
1480, 1490, 1500, 1510, 1520, 1530,
1540, 1550, 1560, 1570, 1580, 1590,
1600, 1610, 1620, 1630, 1640, 1650.

GeX All the above plus 1060. Same as above