EXFO ETS-1000 - Manual (Page 62)

Configuring and Starting a Test
54 ETS-1000
RFC 2544 Test Parameters Setup
Frame Loss Test Setting
The objective of this test is to find the percentage of frames that are lost
due to lack of resources. The test is performed for a specific frame size and
for the specified duration.
The Frame loss test is performed for each defined frame size.

Enabled: Enable (Yes) or Disable (No) the Frame loss analysis.

Trial, s: indicates the period of time during which the test is performed
for each of the specified frame sizes. The accepted range is 1 to
2886 seconds.

Steps, %: indicates the number of rate changing steps in percentage.
The accepted range is from 1 to 10 %.

Start rate, %: indicates the range of physical rates value at which the
test starts for each of the specified frame sizes.

Stop rate, %: indicates the range of physical rates value at which the
test stops for each of the specified frame sizes.