EXFO ETS-1000 - Manual (Page 161)

Remote Control Commands
Ethernet Tester Analyzer 153
bert pattern user / crtp / 2e11-1 /
2e15-1 / 2e20-1 /
2e23-1 / 2e29-1 / 2e31-1
select standard or user-defined
test pattern
bert user-pattern hex set user-defined test pattern
bert frame int set user-defined frame size
bert rate int set user-defined rate (Kbps)
bert duration hh.mm.ss set trial duration for BERT
Packet jitter
jitter port a/b
select port on which jitter
measurements
will be performed
jitter threshold int set treshold (ms)
txgen duration hh.mm.ss set trial duration
Test traffic
txgen header src mac
XX:XX:XX:XX:XX:XX
set source MAC address
txgen header src ip i.i.i.i set source IP address
txgen header src udp text set source UDP-port number
txgen header dst mac
XX:XX:XX:XX:XX:XX
set destination MAC address
txgen header dst ip i.i.i.i set destination IP address
txgen header dst udp text set destination UDP-port
number
txgen header vlan enabled off/on enable/disable VLAN parameter
txgen header vlan id text set VLAN identifier
txgen rate set user-defined rate (Kbps or
%)
Command Operation